How To Stop A Leaky Roof Cincinnati

You don’t need the help of a professional roofer to handle minor roof leaks in your home. Here are some useful tips on how to identify problems on your roof and make the necessary repairs to different types of roofs. If you’re planning on repairing a leaky roof in Cincinnati, you should do it on a sunny day to avoid any slip and fall accidents.

Start by checking for damage in the shingles above where the leak is pouring in. if you have a flat roof, it will be easier to find but some leaks might actually be located a little distance further than the actual roof damage. On that note, if you have a slanted roof, you should check for damage in the areas higher than the leakage. If there’s an attic in your Cincinnati home, you should inspect it thoroughly using a flashlight to check for mold, black marks or water stains.

Also, you can run a hose along different areas of the roof and someone inside should let you know where there’s a leakage. Don’t forget to check curled, damaged and missing shingles near the area where the roof is coming in. Check thoroughly for any exposed roofing tacks as well. If there are any curled shingles, you should straighten them back. For that, you should soften the edge of the shingle with heat but not with an open flame.

You should use asphalt roof cement to reattach curled shingles after straighten them out with a heat source. If the shingle can be lifted off the roof with very little effort, crumbles or breaks, you should replace it immediately. After lifting it off, you should remove any leftover roofing cement beneath it. With a utility knife, round the back corners after installing a new shingle and use roof cement and galvanized nails to put it in place effortlessly.

Start by looking for blisters or cracks in the roofing material in place in your home. If there are any, you should mend the blisters. Use a utility knife to cut through the blister but avoid cutting the sound roofing felt. Squeeze it out to remove the water inside and make it completely dry. Use roofing cement under the roofing material and press it down. Nail it down using some nails along each side of the newly repaired blister. Finally, cover the entire area with roofing cement, as well as the nail heads for the best results.

If there are any damaged shakes, you should split them using a chisel and hammer. Using a hacksaw, cut off the ends of any pried out nails but you should work around the nails if you can’t use the saw without damaging the good shakes still in place. Use a saw to cut out a new shake, which should be smaller in size compared to the older and damaged one. Replace the damaged shake with the new one and hammer it into place. If there are some old nails still in place, you can cut a few notches into the new shake to allow it to fit into place effortlessly. You can use a nail set to set the heads and use a caulking compound for sealing purposes.

Start by inspecting the areas where the surfaces connect such as the vent pipe or chimney. If there’s damage to the caulking, reapply it immediately. Remove the old one completely to allow the new application to bond to the flashing surface or roof satisfactorily. Note that, if there’s any damage to the flashing found near the chimney or the boots close to the vents, you might need to replace these features entirely.

In conclusion, these are minor repairs that you can handle on a leaky roof personally without necessarily hiring a professional roofer. However, you can always do it if you don’t know your way around the roof. When hiring a roofing professional in Cincinnati, you need to do a lot of research. Certainly, you don’t want to be conned by someone looking for some quick money. Therefore, you should hire someone who has been in the business for a long time and has enough experience handling the type of roof installed in your home.

Are you looking for the roofing in Northern Kentucky.